Skip to content
You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
You are viewing the article in preview mode. It is not live at the moment.

Programming Additional Fingerprints After Admin Setup

When enrolling fingerprints beyond the first two admin fingerprints on your Vaultek safe, you must first authenticate with an existing admin fingerprint.

Steps to Program Additional Fingerprints

  1. Scan an admin fingerprint first - Before programming fingerprint #3 or any subsequent fingerprints, you must scan one of the two admin fingerprints that were previously enrolled.

  2. Wait for the #1 key to blink - After successfully scanning an admin fingerprint, the #1 key will start blinking, indicating the safe is ready to accept a new fingerprint enrollment.

  3. Proceed with fingerprint enrollment - Once the #1 key is blinking, you can continue with programming the additional fingerprint.

Expected Behavior

  • You should hear a beep and see the LED blink green when the admin fingerprint is recognized
  • The #1 key will then start blinking red, confirming the safe is in fingerprint enrollment mode
  • If the #1 key doesn't start blinking, ensure you're using a properly enrolled admin fingerprint first

Feedback

0 out of 0 found this helpful